View Single Post
Old Oct 11, 2012, 10:13 AM
Del-Dredd is offline
Find More Posts by Del-Dredd
Registered User
Del-Dredd's Avatar
Near Aberystwyth - Wales
Joined Aug 2004
2,134 Posts
Sounds weired Matt, if you switched over M1 and M2 connections at the KK2 end and then motor 2 now connected to M1 plug is playing up, it would indicate the KK2, you swapped that and still getting same issue, very strange.

I would disconnect everything then as Brontide suggested check each motor/ESC combination directly to throttle channel of the Rx.

Do the factory reset on the KK2's and reflash with nothing connected to them.

Reconnect everything making sure connected right and try again.

Did you check the ESC programming (not calibration) as I mentioned in my post to ensure they are all set the same.
Del-Dredd is offline Find More Posts by Del-Dredd
Reply With Quote