View Single Post
Old Oct 11, 2012, 03:52 AM
Mike Barton is offline
Find More Posts by Mike Barton
Registered User
United Kingdom
Joined Nov 2008
2,035 Posts
Quote:
Originally Posted by teopbako View Post
Now it is working!!!!!
If i run OpenAero2 it works fine.
When i upload the KK2 V1.2 FW it doesn't freeze up as it did in the past bad shows a Gyro: NOT OK!!!!
The same gyro is working fine in OpenAero2 FW
Just because it says 'NOT OK', does not mean the gyro does not work !
There is a simple check on the gyro output voltage: if it is in the expected range, there won't be any error message

It just means that the range checks are different between the 2 different softwares (hardly suprising!)

What numbers are you getting for your gyros, and do they change when you move the board (<- this means thay are *probably* OK) ?
Mike Barton is offline Find More Posts by Mike Barton
Reply With Quote