Thread: New Product Spektrum DX18
View Single Post
Old Oct 10, 2012, 08:48 PM
freechip is offline
Find More Posts by freechip
Air, Ground & Water
freechip's Avatar
Canada, ON, Rockland
Joined Aug 2008
26,839 Posts
Try to increase throttle travel at the top end. Some esc don't arm because there looking for low throttle but where they look for it is so low that some rx need to have some throttle adjustment done.

Maybe you need to do the same for high throttle. Adjusting so it goes just a bit higher.

I read the gyro post again it to access the menu it needs to see full throttle. Either the board is defective or its simply just not seeing full throttle.

Increase throttle and see what happens. Remember Trim does not from mid to high throttle.
freechip is offline Find More Posts by freechip
Reply With Quote