Thread: New Product Spektrum DX8 & DX10
View Single Post
Old Oct 10, 2012, 05:53 PM
shultz is offline
Find More Posts by shultz
Registered User
United States, NV, North Las Vegas
Joined Sep 2009
1,075 Posts
I've ran into a little problem using my new DX8 in place of my DM8 module and 9C.

With the module I didn't have model match, nice feature to have but it's causing an inconvenience when using using a satellite and Copter control board.

I use the copter control board W/ satellite on a micro quad and Tri copter, switching between the two is simply unhooking the ESC leads removing 3 nuts and mounting the module on the tri or quad. I then flash the board with the correct configuration and fly... well I use to without model match!

Now that I'm using the DX8, model match is requiring me to rebind the satellite each time I switch between the two copters, is there any way to turn off model match? Is it possible to have 2 model memories using the same reveiver ID? I tried copying the quad memory to another slot thinking the bind data would transfer with it...nope.

Rebinding each time is not really a big deal... just a step I'm not use to doing when switching between these two small multi's.

shultz is offline Find More Posts by shultz
Reply With Quote