Thread: Discussion Hobby King Bixler 2
View Single Post
Old Oct 10, 2012, 05:48 PM
Sculptor is offline
Find More Posts by Sculptor
AKA, Cheap Chiseler
Sculptor's Avatar
United States, FL, North Fort Myers
Joined Mar 2012
1,267 Posts
Name: Rc Motor 3.gif
Views: 537
Size: 194.2 KB
Description:

I cut the top of the motor housing and removed the stock motor and it's too small wires. Flip the mounting can around and screwed the new 2200kv motor to it and shoved it back in leaving the motor on the outside.

I don't want to glue all this back together then have to change out a motor are go back to stock motor and cut it out again. The side walls of the motor housing are thin, this motor is powerfully only if I glue this can in with enough contact area to keep it still will it be what it should be and with that much glue I'll not be able to get it out.

So I'm going to use Zip ties and squash it in place, what do y'all think?

DJ
Sculptor is offline Find More Posts by Sculptor
Reply With Quote