View Single Post
Old Oct 10, 2012, 12:24 PM
roadsplat is offline
Find More Posts by roadsplat
Registered User
Central Michigan
Joined Nov 2005
191 Posts
[QUOTE=xandrios;22955250]Try connecting these 2 pins together. It should power up.

After some more playing around I found that if I connect the 4 pins I have indicated in red together the unit would power up. Not sure if that's correct but it seems to work. Also as indicated in the photo attached....the two big post at the far left are the 12v lines, the 4 post next to them are the grounds. On the right side, two posts are 5 volt and two are 3 v. Not sure what the other big post in the lower right corner is.

Thanks for pointing me in the right direction. Appreciate it.

RC
roadsplat is offline Find More Posts by roadsplat
Reply With Quote