View Single Post
Old Oct 10, 2012, 08:25 AM
Prof100 is offline
Find More Posts by Prof100
Registered User
Prof100's Avatar
Canton, Michigan USA
Joined Jul 2007
16,800 Posts
Quote:
Originally Posted by choochoo22 View Post
Not an ideal solution but there is a way to reset at the field without a computer. To set up a 2 pos switch for 2D/off or 3D/off you have to have the travel set in the tx to zero (neutral) in one direction and typically max travel in the direction of the desired mode. So, to do a reset with the tx just program the neutral direction back to max travel so you have 2D/3D. Do the reset. Then put the travel back to neutral.

Fortunately this doesn't need to be done often, especially after a plane is set up. This method is a bit awkward but a lot easier than lugging a laptop to the field and fishing around for the USB connection.
If I understand his dilemma it is that he has no spare channels in his receiver to accept the MOD connector from the Guardian.
Prof100 is offline Find More Posts by Prof100
Reply With Quote