View Single Post
Old Oct 10, 2012, 06:43 AM
r3dskull is offline
Find More Posts by r3dskull
almost hovering
r3dskull's Avatar
United States, FL, Homestead
Joined Feb 2012
33 Posts
Originally Posted by MikeHRC View Post
How are you mounting the FBL unit - which tape? The wrong tape can cause issues.

Also I saw a picture of your 450 where you were using a cable tie to hold it - this will transfer vibes into the unit (unless you have the cable tie in fuel tubing or similar), also your FBL unit was not perpendicular to the main shaft
efx, I prefer to swap the RX and gyro locations (gyro inside frame, rx out) and like Mike says don't use tie with this gyro, I just use the double side foam tape.

Also have you check the gyro corrections on the bench, just move it hard to each side and check. I don't know if that gyro is like the zyx with an option for pirouette optimization also.
r3dskull is offline Find More Posts by r3dskull
Reply With Quote