Thread: Discussion Dynam Sky Trainer Cessna 182
View Single Post
Old Oct 10, 2012, 04:42 AM
hydro_pyro is offline
Find More Posts by hydro_pyro
Blade mSR freak
hydro_pyro's Avatar
Irish Hills - SE Michigan
Joined Jan 2010
2,054 Posts
Lay a soldering iron against the screw head until it wiggles, then it should back out easily, even if the head is rounded out a bit.

The plastic inserts are drilled, but not tapped for the screw threads. Sometimes they fail to cut their threads when you first screw them in. If the screw is slotted with a Dremel for a flat screwdriver, you might be able to try it again with the screw heated up a bit.
hydro_pyro is offline Find More Posts by hydro_pyro
Reply With Quote