View Single Post
Old Oct 10, 2012, 04:07 AM
choochoo22 is offline
Find More Posts by choochoo22
Rick
United States, CA, Santa Clara
Joined Mar 2011
2,243 Posts
Quote:
Originally Posted by Galand View Post
I did that, but I was hoping to be able to do that in the field since it seems to be recommended to reset Guardian trims after doing radio trimming.
Not an ideal solution but there is a way to reset at the field without a computer. To set up a 2 pos switch for 2D/off or 3D/off you have to have the travel set in the tx to zero (neutral) in one direction and typically max travel in the direction of the desired mode. So, to do a reset with the tx just program the neutral direction back to max travel so you have 2D/3D. Do the reset. Then put the travel back to neutral.

Fortunately this doesn't need to be done often, especially after a plane is set up. This method is a bit awkward but a lot easier than lugging a laptop to the field and fishing around for the USB connection.
choochoo22 is offline Find More Posts by choochoo22
Reply With Quote