View Single Post
Old Oct 09, 2012, 09:08 PM
Sudsy is offline
Find More Posts by Sudsy
It's Just a Hobby!
Sudsy's Avatar
Joined May 2012
1,203 Posts
Setup Problem

I am trying to set up a KK2 board with 1.2 firmware. The receiver test shows both throttle and elevator as "no signal". The aileron channel is ok. I am using a DX7 and an Orange 7 channel rcvr. If I move the aileron input to the elevator channel it (elevator chan) then works with aileron stick movement. The ESC's are programmed (Turnigy 12 amp). I cleared the DX7 and reset everything there and did a bind. No change.

This is the first of two boards I received. I tried to set this one up when it arrived and had not luck. I even think it has fried two receivers since they will no longer bind. The second board I got gave me no trouble.

Should maybe I try a "factory reset"and one more bind before I start the long process of returning something to Hobby King.

Oh yea, I have compared the settings from the second board when it arrived the other day and they are the same as the number one board.

Sudsy

Aux discrete is working fine. I have it on the Gear switch. (chan5) Rudder works fine also.

Sudsy
Sudsy is offline Find More Posts by Sudsy
Last edited by Sudsy; Oct 09, 2012 at 09:10 PM. Reason: add last line
Reply With Quote