View Single Post
Old Oct 09, 2012, 08:39 PM
goflyhighrc is offline
Find More Posts by goflyhighrc
Just go with the flow
goflyhighrc's Avatar
Joined Nov 2006
3,355 Posts
Quote:
Originally Posted by Huang View Post
A bit hard to explain this, it's not the latch is being restricted. The latch pin is already fully extended, but still does not go all the way through the ply doubler. It only has enough reach to go through the canopy balsa bulkhead.

It could be my canopy is slightly warped, or the canopy back plate is glued slightly inner to where it should be. It's just 1-2mm off but the latch can't hook onto the ply doubler when fully extended. Does it need to hook onto the ply doubler?

I'd rather not have to use the thumb screws if possible. Hard to disconnect the battery quickly in case anything happens.
I've glued a washer to the back of my canopy, it worked great
goflyhighrc is offline Find More Posts by goflyhighrc
Reply With Quote