Thread: Discussion 3d printing
View Single Post
Old Oct 09, 2012, 08:06 PM
olmod is offline
Find More Posts by olmod
Good Better Best quest.
olmod's Avatar
Australia, VIC, Langwarrin
Joined Apr 2004
10,592 Posts
Talking with a friend last week he uses a 3d printer to make a master pattern from wich plastic dies are are made then those dies are installed into a injection moulder that uses a 2 part urethane mix to mass produce parts,not the cheapest way to produce though as the cycle times are in minutes not seconds.
olmod is offline Find More Posts by olmod
Reply With Quote