View Single Post
Old Oct 09, 2012, 03:16 PM
copterfilms is offline
Find More Posts by copterfilms
Close Range Aerial Imagery
copterfilms's Avatar
Argentina, Autonomous City of Buenos Aires, CF
Joined Feb 2006
66 Posts
OlliW,
Looking much better now! Thank you again for the valuable info.
According to the multimeter (+3.3v readout) the lower pad correspond to GND the next one right above is VCC, i updated the picture with the findings for others looking after the same mod with this ESC.
Next step is to set up the Arduino programmer and find the C2CK and C2D.
Still need to know which HEX file is the correct one for this ESC.
Will come back with more news
Going in the right track now.

Victor
copterfilms is offline Find More Posts by copterfilms
Last edited by copterfilms; Oct 09, 2012 at 05:21 PM. Reason: Replace Image
Reply With Quote