View Single Post
Old Oct 09, 2012, 03:10 PM
GlowFly is offline
Find More Posts by GlowFly
Registered User
GlowFly's Avatar
Midlands, UK
Joined Jun 2004
1,338 Posts
Quote:
Originally Posted by mattijs321 View Post
and you don't have to use the trainer port to control the module?
I can think of three ways to use 3rd party PPM based modules with an Evo and firmware v3.xx.

1. Use the trainer port which still provides PPM.

2. Fit a small custom board that accepts the Evo serial data on the module port and in turn generates PPM for a module with a slight delay. There is a thread on here where this is done.

3. Fit a small custom board that answers the Evo power up inquiry via the serial interface on the module port pretending to be a later type 35MHz RF module. The Evo will then generate PPM on the module port even with v3.xx as that is how the module works!

Steve
GlowFly is offline Find More Posts by GlowFly
Reply With Quote