View Single Post
Old Oct 09, 2012, 02:41 PM
AcroFPV is offline
Find More Posts by AcroFPV
we dont NEED roads!
AcroFPV's Avatar
United States, CA, Rocklin
Joined Aug 2012
3,496 Posts
These are supposed to be some great motors for Quadcopters:
http://www.hobbyking.com/hobbyking/s...dProduct=17345

Also I would not be afraid to try these ESC's:
http://www.hobbyking.com/hobbyking/s..._ESC_2_4S.html

If you can solder, a power distribution board is a waste of $$$ You can achieve the same by just creating a wiring harness. This is my harness:


I just took two strands of wire, and stripped about an inch of insulation away from the center. Then I untwisted both and made the exposed wire flat. Then stacked the two flattened wires ontop of eachother, and twisted them together, along with an extra lead for auxiliary power. This was for my Tricopter, so I only needed Power IN & 3 motor outputs. Then solder it all together and cover with shrink-tube. I did this twice, once for a positive and again for the negative.
AcroFPV is offline Find More Posts by AcroFPV
Reply With Quote