View Single Post
Old Oct 09, 2012, 10:05 AM
Matt Halton is offline
Find More Posts by Matt Halton
Wannabe B-26 pilot!
Matt Halton's Avatar
Southwold, Suffolk, UK.
Joined Nov 2002
5,059 Posts
My board works!!

Ok, I got a new board from HK this morning, set it up to try and darned reciever test showed no signal to ail again ...

Took rx and wires (male/male) off to test away from the ESC's, put it all back, then find that the throttle has no signal..I must have swapped cables inadvertantly, so determined that the cause of my ongoing board misery was all due to one dodgy cable connection -I'm certain I tried swapping them before to check whether the cable was faulty, but seems I must have very stupidly overlooked something.

Soldered up a replacement cable from 2 servo extension leads, it all works perfectly now!

I used these settings, does that look ok?

gyro aileron\elevator
p gain 35
p limit 100
i gain 25
i limit 20
gyro rudder
p gain 45
p limit 100
i gain 20
i limit 20

self lev
p gain 65
p limit 65
i gain 0
i limit 0

So now I'm ready to flash the board, can anyone reccomend any newer version I can can use please?

About to balance the props and motor cans, then hopefully ready to actually FLY later this week

Thanks

Matt
Matt Halton is offline Find More Posts by Matt Halton
Reply With Quote