View Single Post
Old Oct 09, 2012, 08:03 AM
trumps is offline
Find More Posts by trumps
What's 3D?
trumps's Avatar
Australia, WA, Ellenbrook
Joined Feb 2008
3,321 Posts
hooked up the elevator push rod, and rudder pull/pull, which is the usual plastic coated beading wire and crimps cut from brass tube. the radio gear access hatch is secured with a couple of countersunk screws which anchor into a couple of 3/16 rails in the fuse.
i am not much chop at decking out cockpits so this one is going to be very basic, just the top half of the instrument panel which was made out of some .0020" styrene card glued to some 1mm balsa sheet. the gauge bezelswere cut from styrene sheet and glued in position, the gauge faces are just ones downloaded from the www.com, scaled to suit, cutout and glued in with a drop of canopy glue on top of them which when dry is the instrument glass.

Craig
trumps is offline Find More Posts by trumps
Reply With Quote