Thread: Discussion Mills .75cc model diesel engine
View Single Post
Old Oct 09, 2012, 02:52 AM
robinson727 is offline
Find More Posts by robinson727
robinson727
USA, MS, Byhalia
Joined Nov 2010
139 Posts
All..
I have written Hans at CS and he has sent me enough .075 parts to build a Mills inline twin. Has anybody measured the CS copy co I can verify my dimensions?
What I need are crankpin dia, shaft journal dia and stroke. Rather than hassle with a new block this is going to be a siamese with a modified rear case and a new design crank, (like the Sparey twin) so it's essentally 2 back to back cases with the snout cut off the rear casting and a threaded outer housing to tie them together in the threaded back plate area. CS also sent me an RC carby for a 1.3 for it, they have been very helpful and seem interested in our results.
Thanks
Al
robinson727 is offline Find More Posts by robinson727
Reply With Quote