Thread: Question I did what I could
View Single Post
Old Oct 08, 2012, 11:55 PM
roballoba is offline
Find More Posts by roballoba
damn you tree!
roballoba's Avatar
Foster City, CA
Joined Dec 2005
233 Posts
helping Aisamac

when working on Aisamac's OSD pro, it would not work.

latest beta software loaded to windows 7 64bit pc.

We got the elogger plugged into computer with the firmware to updated to 1.21
the on board led blinks 3 times to indicate it is connected.
with nothing else connected to the elogger, we get live view mode to work showing us battery voltage.

when we plug in the OSD pro to elogger, (without it plugged to computer,) on the pins closest to the usb plug (closest to the label side) I assume this is the bottom, we get video transmission to work. The video passes through, but there is no data on the screen. (plugged to middle pin set, the eagle tree logo is transmitted, but only when connected to computer with usb. plugging OSD into top? pin set does nothing, but I assume this is the GPS spot - label is unclear as to what is top or bottom.

when plugged to usb, the computer flashes msg that USB device is not recognized.
in the eLogger software, the firmware control does not recognize the osd, or any other device.
when we go to live view, the software stated osd is not connected.
when we unplug the osd, the live view works.

it's not happy.
roballoba is offline Find More Posts by roballoba
Reply With Quote