Thread: Discussion Parkzone P47
View Single Post
Old Oct 08, 2012, 06:12 PM
kalmon is offline
Find More Posts by kalmon
Parkzone junkie
kalmon's Avatar
United States, MI, Grand Traverse
Joined Oct 2008
3,924 Posts
Quote:
Originally Posted by jtaylor996 View Post
That's the correct motor, but you may need to adjust the pitch down on that to pull less amps. Some of this depends on whether you're running 4s or 3s. I suggest going over things on eCalc first.

You don't need the metal motor mount for any reason I can see. I still can't even figure out why that thing exists...

The power 25 bolts right up, perfect spacing. Heat is not an issue in melting the stock mount. If it was, the metal mount would just melt the firewall.
The other option would be the Power32 770kv, this motor is only about 10g heavier than the 25 and should allow you to run that 4 blade prop at the stock 10 pitch.

+1 on checking out eCalc first through.
-Brian
kalmon is offline Find More Posts by kalmon
Reply With Quote