Thread: Discussion 3d printing
View Single Post
Old Oct 08, 2012, 06:04 PM
BillzillaAus is offline
Find More Posts by BillzillaAus
My cat moderates better
BillzillaAus's Avatar
Australia, QLD, Worongary
Joined Apr 2011
815 Posts
Quote:
Originally Posted by carl1864 View Post
I'd be pretty concerned about this. Sure replacing the part is cheap, but considering its a part that holds a $300 camera, it could cost a lot. Especially if the gopro was being used as an fpv camera, then you loose the plane too. Or if you make a motor mount, or control linkage that fails.
It broke because I can't do aerobatics for shyte and smacked it into the ground quite hard. It's otherwise more than strong enough.

F550 local park FPV flight, and crash (9 min 5 sec)
BillzillaAus is offline Find More Posts by BillzillaAus
Reply With Quote