Thread: Discussion Parkzone P47
View Single Post
Old Oct 08, 2012, 05:41 PM
jtaylor996 is offline
Find More Posts by jtaylor996
Registered Crasher
United States, TX, Coppell
Joined Feb 2011
2,226 Posts
That's the correct motor, but you may need to adjust the pitch down on that to pull less amps. Some of this depends on whether you're running 4s or 3s. I suggest going over things on eCalc first.

You don't need the metal motor mount for any reason I can see. I still can't even figure out why that thing exists...

The power 25 bolts right up, perfect spacing. Heat is not an issue in melting the stock mount. If it was, the metal mount would just melt the firewall.
jtaylor996 is offline Find More Posts by jtaylor996
Reply With Quote