Originally Posted by HuskySpade
I heard this was possible! And i'm really excited to try it out because I feel the 9116 Tx has a little bit more to offer than the V911 Tx.
The procedure that needs to be followed is:
RUD and AIL on the 9116 Tx need to be switched from REV to NOR in order for it to properly control the V911. And then switch back from NOR to REV to control the 9116.
Is this correct?
That is correct. The only issue we have found so far is that the RUD trim doesn't seem to work. All other trims seem to however.