Thread: New Product Techone POPWING and MINIPOPWING
View Single Post
Old Oct 08, 2012, 11:19 AM
uavrat is offline
Find More Posts by uavrat
Registered User
Joined Jan 2012
75 Posts
900 build

Attached are photos. As you can see I modified the build a bit. Where the equipment and battery bay go, I simply cut that foam out and re-glued it back in place so the bottom of the wing is smooth. But locations are exactly the same.
It can be wet or snow around here and I just see little sense in that design to hang batteries and electronics on the bottom of a wing.

I added strapping tape to the leading edge, and to the rear near the prop. First toss or two had prop chew a chunk from that trailing edge.

Thanks for the input.

Notes: I did check motor alignment this morning, looks straight as an arrow.
When I toss just to do a glide test it does like a little bit of up elevon, then it seems to glide nice. But when I apply power and try a turn to the right it dives straight down.
uavrat is offline Find More Posts by uavrat
Reply With Quote