View Single Post
Old Oct 07, 2012, 04:59 PM
GeorgeG97322 is online now
Find More Posts by GeorgeG97322
Power Upward
GeorgeG97322's Avatar
United States, OR, Albany
Joined Jun 2007
1,563 Posts
Here are my Reset Tools... Notice that the working end of the kirn kraft tool has been reduced in diameter. This is done to protect the piston skirt from being hit by the tool if it is allowed to lean while being struck by the hammer. The piston anvil was turnned on a lathe and is used to kepp the piston from being forced out of round and it makes holding everything easier while resetting the rod.

George
GeorgeG97322 is online now Find More Posts by GeorgeG97322
Reply With Quote