View Single Post
Old Oct 06, 2012, 04:06 PM
kingsflyer is offline
Find More Posts by kingsflyer
We shall serve the Lord
kingsflyer's Avatar
United States, TX, Kingsland
Joined Sep 2005
5,478 Posts
I've used CorrosionX for over three years now without a failure. CorrosionX has a 40,000 volt dielectric property and will not degrade printed circuit boards or their components. This is very important for our 2.4 gHz receivers that can be effected by very low voltage leaks across the lands of the printed circuit boards.

I've never tried Corrosion Block so I can't give you a comparison. However, the Corrosion Block site does not address any electrical properties of the product, or if it is safe for electrical printed circuit boards or components.

McD
kingsflyer is offline Find More Posts by kingsflyer
RCG Plus Member
Latest blog entry: LEDs on my T-28
Reply With Quote