Thread: Build Log Oculus RES Build
View Single Post
Old Oct 06, 2012, 10:13 AM
vfrank59 is offline
Find More Posts by vfrank59
Registered User
vfrank59's Avatar
Joined Jan 2007
84 Posts
Quote:
Originally Posted by target View Post
Vern-

The beveled rib was supposed to glue in at the root of the tip panels. Then the plywood 1/16" cap rib glues outside that. You will end up with two plywood 1/16" ribs butted together where the joint is and yes, the dihedral wing joiner is what goes in unglued to the tube spars to join the wing panels when flying.
Tape is used to keep the panels from sliding apart in flight.
After flying, un tape the wings and you have a center section and two tips.
ok, thanks for the info. I have already used the normal 1/4 in rib and glued the 1/16" plywood cap. So, it will not be a hard re-do repair. I see at the bottom right of the print showing the angle rib and 10 degree angle. It was covered up by all the glue and tools sitting on top of that portion!! crap!

thanks,
Vern
vfrank59 is offline Find More Posts by vfrank59
Reply With Quote