View Single Post
Old Oct 06, 2012, 12:43 AM
Aerhead is offline
Find More Posts by Aerhead
Aerhead
MN
Joined Mar 2009
216 Posts
rkenosha

The setup for my DX7 was probably the easiest part of the AQ learning curve. You just have to select 10 bit or leave it at the default 11 bit and the system will work. First you must have linked the Tx to the spectrum satellite by temporally connecting the satellite to a spectrum rx. Then just plug the spectrum satellite into the board. The channels will show up in the GCS but you will still need to set the Tx so the flight mode switches work the way you want.
The AQ is likely the best autopilot for multicopter photography but currently not a good choice for someone inexperienced with multicopter autopilots.

Quote:
Originally Posted by rkenosha View Post
This is a noobie tx question. I presently own a Spectrum DX8 and arm8000 receiver. What would I need to make this work with the Autoquad? If it will. Thanks rkenosha
Aerhead is offline Find More Posts by Aerhead
Last edited by Aerhead; Oct 06, 2012 at 12:54 AM.
Reply With Quote