View Single Post
Old Oct 05, 2012, 10:00 PM
m_beeson is offline
Find More Posts by m_beeson
FPV junkie
m_beeson's Avatar
United States, UT
Joined Jan 2011
3,610 Posts
PCM (RTH)


and


3 + failsafe channels.


Then you just set your failsafes in your radio to Level flight, and throttle off and trimmed all of the way down.


With the Futaba, it is a little trickier, because you have to set each channel separately.

Once you Maiden the airframe, and get it trimmed to level flight, then you will want to re-set failsafes in the radio, and run servo analysis wizzard again.

each time you make a change to trims or guardian level flight setting, then you want to re-run servo analysis wizzard. This way you teach your osd the new settings.

-Mike

Quote:
Originally Posted by stevo6739615 View Post
Hello, I am using a futaba 10cag 2.4 and I have a question what should I configure my failsafe settings for on my radio and which setting up the RTH with recievers should I choose on the OSD radio control configuration menu? Please help I would greatly appreciate it.

Thanks,

Steve S.
m_beeson is offline Find More Posts by m_beeson
Reply With Quote