View Single Post
Old Oct 05, 2012, 08:49 PM
Gordosoar is offline
Find More Posts by Gordosoar
Sabre holic
Gordosoar's Avatar
Beverly Hills, Florida
Joined Nov 2006
2,223 Posts
Quote:
Originally Posted by Asymair95 View Post
The Axon is done, hope to maiden next week. It is balanced, but just barely. I had to move both 3.3 batts to the very nose of the plane. Had I mad the lower fuse section a tad bigger the batts would have slid inside the twin hulls. They fit now, but are very tight. I do have the glitch problem with my new 9 gram servos, but it's flyable. What i did not like was the gyro I bought for this plane. It is very glitchy and does not move the control surfaces well. I have the ailerons on a Y harness, but not sure if that is what is causing it. I bought 2 of them and they both do it.
It's always a good idea to balence the fully loaded fuse on top of the wing to get a good CG location BEFORE installing the wing permanently.
I find that I always need to move it back an inch on the fuse after balancing to compensate for the servos in the wing that are aft of the CG on the wing.
Confused yet?
Gordosoar is offline Find More Posts by Gordosoar
Reply With Quote