View Single Post
Old Oct 05, 2012, 04:54 PM
cracksmeup is offline
Find More Posts by cracksmeup
Registered User
cracksmeup's Avatar
United States, IL, Joliet
Joined Jun 2009
3,603 Posts
Quote:
Originally Posted by Freddie B View Post

I cleaned and cleared the workbench again. Where did everything go.......


Well it was needed so I could layout all the airframe parts to start final assembly! The airframe is going to be a bit larger than I normally build so I needed the room. This bench is 4'x4' square BTW.

Fred


I have a lower fold up table 3ftx3ft to catch the over flow of tools and to hold my building radio , my work bench is 10 ft with 1940s flouresent 25 pound each heavy lamps at both ends so my old eyes can see. I just found a giant magnifying lamp that uses a round flouresent builb underneeth for close up work . If my eyes get any worce i will be flying big gas 3-d stuff and hover them close to me so i can see them like the rest of the nuts at my club field. lol
cracksmeup is offline Find More Posts by cracksmeup
Reply With Quote