View Single Post
Old Oct 04, 2012, 07:21 PM
isaacintheclouds is offline
Find More Posts by isaacintheclouds
Support yer local CharlieSheen
isaacintheclouds's Avatar
United States, CA, Carnelian Bay
Joined May 2011
1,400 Posts
Quote:
Originally Posted by Skytop Ryan View Post
Hi all, I am new to forums but need help, so if I am doing anything wrong I apologize in advance. I have seen a few posts about the WooKong- M CFG-ERR(8) but still nothing fixes mine.
I updated the firmware and now all I get is a fast blinking red led. I have tried updating the firmware again and the same thing happens. I have re-calibrated the tx multiple times and still nothing. I am running out of options any help will be appreciated.

Thanks
Could be several things. Try uninstalling the assistant software and re-installing. Also, mine seemed to like it if I opened the assistant, plugged in the MC and then powered the MC up. If you can, disconnect the escs, or take off the props before you try programing the MC. I have heard a few horror stories of the motors spooling up in the middle of an upgrade causing prop cuts to the pilot!
isaacintheclouds is offline Find More Posts by isaacintheclouds
Reply With Quote