View Single Post
Old Oct 04, 2012, 04:03 PM
Al Lowrie is offline
Find More Posts by Al Lowrie
Al Lowrie
United States, WY, Cheyenne
Joined Oct 2012
5 Posts
My APM.2.0 was damaged simply by unplugging and swapping 2 of the servos at the RX while powered by the flight LiPo and plugged into the usb port. A very small surge can cause the damage. Its not a big deal, just run a second line to the input rail w/ a 5V bec. You can run both sides of the board on the same battery. I have been flying this way for quite some time.
Al Lowrie is offline Find More Posts by Al Lowrie
Reply With Quote