View Single Post
Old Oct 04, 2012, 01:26 PM
Jon Snow is offline
Find More Posts by Jon Snow
You know nothing....
Jon Snow's Avatar
Joined Sep 2011
3,622 Posts
Bit more progress.The brass boxes cut and fitted,very snug fit.The tube ends showing on the edges are to take the drive arms,one above and one below the shaft centre.All the tube here will be replaced with carbon;I've ordered a length of 6mmx4mm and one 4mmx3mm to fit inside it.These two,along with a piece of 3mm steel shaft will enable me to try the direct link I speculated about earlier,or form attachment points for the rod ends.
Stuart
Jon Snow is offline Find More Posts by Jon Snow
Reply With Quote