Given how long my 1/87 scale Rc coach thread has stood still I probably won't start a thread on it till I have the airframe assembled and some kind of link rod/pull-pull gut in tube system working.
If one of the above methods do not work I may need your services, could the same chip as the "DaveConverter" do the following.....
Read the centre pin of a pot (on the V911 board servo) and output a servo signal, in the PM mentioned project a pair of 1.5g servo would be much easier to implement.
Why this would mean for anyone else would be a way adding a pair of external servos to pitch and roll channels of such a heli board to be used in a plane or whatever
I'll send you a new PM with all the details for me to get a "DaveConverter" (could a custom Dave converter do two motor to PWM and two Servo POT to PWM?)
I'll send you a new