View Single Post
Old Oct 03, 2012, 12:29 PM
krysta is offline
Find More Posts by krysta
Registered User
Champaign
Joined Apr 2003
142 Posts
On the main screen in the upper right hand corner directly below 2.4G, it should say either 7ch or 10ch.

But either way, in either 7 or 10 channel, when you go into the End point screen, toggle down to your Aux channel, it should show L or H, if you have that channel set to a dial. You should then be able to turn the appropriate dial or move the appropriate slider to adjust both sides of the end points.

What are they set to in your Aux channel menu?

Also, have you tried going into a blank model to see if you can set the end points in a completely new model?


Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
service@futaba-rc.com

Quote:
Originally Posted by Rick~K View Post
I'm not sure, it shows 8 ch in window and am able to adjust "gear" and toggle sw, just not levers or knob
krysta is offline Find More Posts by krysta
Reply With Quote