View Single Post
Old Oct 02, 2012, 10:22 PM
black6088 is offline
Find More Posts by black6088
Registered User
United States, WA, Ferndale
Joined May 2012
408 Posts
Quote:
Originally Posted by Qualo Kabrigne View Post
The CG listed on the SPECS page of the HZ website says 20mm or .8 inches. This is approximately 3/4 of an inch back from where the wheel wire goes in, towards the battery hatch right?
That's right. As I figure it, the CG is about where the two notches are on the battery hatch plate. When I've had cause to check the CG, I put a large rubber band through those notches, install the cover to hold it in, and hang it upside down to check the balance.

Tom
black6088 is offline Find More Posts by black6088
Reply With Quote