Thread: Discussion Dynam Sky Trainer Cessna 182
View Single Post
Old Oct 02, 2012, 06:32 PM
hydro_pyro is offline
Find More Posts by hydro_pyro
Blade mSR freak
hydro_pyro's Avatar
Irish Hills - SE Michigan
Joined Jan 2010
2,054 Posts
Just put a series resistor on each LED, in the 500 ohm range, and plug the whole shebang into the BEC circuit (+ and - on the Rx.). You'll be playing it more than safe current-wise, on both the LED's and the BEC's regulator. Use 1k resistors if you run it directly off the Lipo pack.
hydro_pyro is offline Find More Posts by hydro_pyro
Reply With Quote