Thread: Question Advice on working with XDP
View Single Post
Old Oct 02, 2012, 12:11 PM
FlyingW is offline
Find More Posts by FlyingW
Build more, websurf less
FlyingW's Avatar
Long Valley, NJ, USA
Joined Dec 2001
1,806 Posts
Question
Advice on working with XDP

I needed to run the XDP program to change the channel mapping on some nano receivers. I had a perceived problem where I thought the XDP program could not see the XDP device.

I have Windows 7. Installed the latest program from XPS (as Administrator) and the drivers installed successfully. Even tried a new usb cable.

Turns out the XDP program was looking for the actual receiver - not the XDP device! It works just fine.

I felt a little foolish, but was relieved to be able to make progress on the project.

Paul
FlyingW is offline Find More Posts by FlyingW
Last edited by FlyingW; Oct 03, 2012 at 07:54 AM. Reason: continuing education
Reply With Quote