Thread: Discussion Strip planking
View Single Post
Old Oct 02, 2012, 08:37 AM
campbelltf is online now
Find More Posts by campbelltf
Registered User
campbelltf's Avatar
United States, NH, Bedford
Joined Jan 2012
322 Posts
And that's how it worked. After making the first pass with the balsa stripper and getting a piece that looks like "B" in the article, I flipped the balsa over so the side that had been face down on the work surface was now face up. I then ran the stripper down the edge I had just made with the previous cut. Perfect plank with edges beveled like "A" in the article. Flip the piece back over and repeat. Went quickly from there. I haven't started gluing yet, hopefully tonight.
campbelltf is online now Find More Posts by campbelltf
Reply With Quote