View Single Post
Old Oct 02, 2012, 12:37 AM
desertstalker is offline
Find More Posts by desertstalker
Registered User
Australia, VIC, Melbourne
Joined Feb 2010
2,088 Posts
The throttle signal to an ESC is a 1-2ms pulse 1ms being 0 throttle and 2ms being 100%. Typically this is repeated at ~50 Hz but it could be faster, no way to know if the ESC will support a faster rate though. This is not really PWM (though you can use a PWM system with a very short duty cycle and low frequency).

The ESC can likely be calibrated to match its idea of 0% and 100% with your controller.
desertstalker is offline Find More Posts by desertstalker
Reply With Quote