View Single Post
Old Oct 01, 2012, 05:59 PM
Ridgehogs is offline
Find More Posts by Ridgehogs
Registered User
Joined Jun 2012
153 Posts
Ridgehogs TR035 Power Plant

Here is the TR035 power plant setup... What I have done is created a mounting plate which acts as a heat sink as well. The plate has various holes so that the pilot can fit various sized outrunners to this to suit their intended need (thermal, slope or hotliner).

The mounting plate screws to the inside of the fuse, the plate on the inside has slotted holes so that if you put a bigger motor in, you can slide the plate back a little.

This also is good when you crash, the whole set up is easy to access/replace with no damage to the fuse/structure.
Ridgehogs is offline Find More Posts by Ridgehogs
Reply With Quote