View Single Post
Old Sep 30, 2012, 05:20 AM
skywalker34 is offline
Find More Posts by skywalker34
Registered User
Joined Jul 2011
19 Posts
hi jalves,

I am following this thread for few week and decided to built my own tracker
I have now received the antenna, 4" Ball Bearing Lazy Susan Swivel Spinner Turntable , slip ring, gears and servo + arduino's board.

I will assemble all those part within very next week

I have downloaded the firmware's file but can't really understand the links between those: I suppose I should open openDY_AT_RX and send (compile) to the arduino board,

but how the other files are connected to the main "openDY_AT..." in your code ?

where should I change the code to use full & unlimited pan rotation ?

I will try to make pictures of # step when assembling my system

Rgds
skywalker34 is offline Find More Posts by skywalker34
Last edited by skywalker34; Sep 30, 2012 at 05:38 AM.
Reply With Quote