Thread: Build Log AeroSky B60 Build
View Single Post
Old Sep 29, 2012, 07:11 PM
sparkie624 is offline
Find More Posts by sparkie624
Registered User
sparkie624's Avatar
Roanoke, VA
Joined Sep 2008
928 Posts
The tail is mounted..... Looks pretty good. See the pics. Plane bigger that you may think. Note size comparison. A note on the tail, it is setup to be tightened with screws and not glued. I found this to be a problem as I could never get the tail tight. The screws were, but the elevator had movement. I ended up using some epoxy.

However, the locking mechanism on the hatch broke... It was on the 2 or 3rd time that it had been installed. Going to replace the latch with Rare Earth Magnets... I have plenty of them and they are cheap.

Wings are next. Going to start them today. Not sure if I will finish or not. Going to save the winglets to be the last thing to install. They appear to be the most fragile part of the model, so I elected to save them to last.

The directions is a decent guide line, but don't follow them precisely... If you do you will not install the flaps or other required items. they missed a lot here.
sparkie624 is offline Find More Posts by sparkie624
Reply With Quote