View Single Post
Old Sep 29, 2012, 02:36 PM
sloperjoe is offline
Find More Posts by sloperjoe
Registered User
sloperjoe's Avatar
United States, WA, Vancouver
Joined Mar 2012
740 Posts
its been sooooooo long since I have done any glass work, I do remember the last intake/exhaust I did was lost foam too, I used 2 layers of the litest Sig glass cloth I could get, stuff was like tissue paper almost, then I used carbon fiber ribbon to add "hoop" supports and some longitudinally on the sides and top/bottom for torsion support, used polyester resin to lay it up, then let it sit for a week to get good and hard, then dumped lacquer wash in it to get the foam out, came out EXTREMELY lite and very very stiff

Joe
sloperjoe is offline Find More Posts by sloperjoe
Reply With Quote