Thread: Discussion Pitts Python from foam to balsa
View Single Post
Old Sep 28, 2012, 11:24 PM
luke352 is offline
Find More Posts by luke352
Registered User
Australia, QLD, Ipswich
Joined Sep 2008
1,349 Posts
Well not many posts but work hasn't stopped. I've just been cleaning up all the little jobs and currently the cowl is drying from being glassed, i'll let it dry and then tomorrow i'll probably give it another coat of resin but this time with some Q cell mixed in, that should hopefully fill the cloth weave and fill any other imperfections. I've also got the motor box fitted and some SWB standoffs as required to mount the motor. I think i'm going to fit the Torque F3A silver bullet motor first as I know it is very capable of spinning a 20"-21" prop whereas the KV on Motrolfly might still be tad high to spin a 20" prop without pulling too many amps.
luke352 is offline Find More Posts by luke352
Reply With Quote