View Single Post
Old Sep 28, 2012, 01:59 PM
mtflyr is offline
Find More Posts by mtflyr
Registered User
Centreville,VA,USA
Joined Apr 2001
4,107 Posts
Looks like you've got it. Remember you'll be adding some down and right thrust to the P-51 shaft. That may give you less room.

Does the P-51 spur and big gear fit inside or do you even need it to with the shaft extension? BTW I have 4 micro brass nuts that will fit the brass shaft extension. I'll put one in the mail with your MG's when I do your motor (I'm going to make two). I'll show you a picture of my Voss DR-I as I just put the extension shaft on mine. It makes it look cool with my soda can aluminum prop hub plate. Well at least if your using the PZ P-51 prop.

BTW did you see in the 1:24 scale paper build I sent the metalic paper the builder used? That could make a pretty good looking motor too.

What glue did you use at first when making the cylinders? Where did you get your card paper?

What's the weight at this point of your motor?

Thanks,

Pete
mtflyr is offline Find More Posts by mtflyr
Reply With Quote