Originally Posted by DuPageJoe
It weighs 13 grams, about half an ounce. Not a bad match to a 60 gram motor, I think. Just laid the motor's X mount on a piece of 1/8" birch ply and TLAR from there. Cut the ply out with my Dad's old Craftsman Jig Saw. I put this stuff in a spread sheet when I build. That's what computers are for.
Hope it works for you
P.S. This is post where mount picture is attached
I went with this one took my hot knife to it got it to 3 grams i just wish I didnt cut out the cross bracing just the bracing only weight about .2 grams