Thread: Discussion olliw co mixer build
View Single Post
Old Sep 28, 2012, 12:29 AM
sonnier00 is offline
Find More Posts by sonnier00
Registered User
sonnier00's Avatar
United States, TX, Huntsville
Joined Oct 2011
257 Posts
I found something that could explane my problem see pic my borad has a diffront end GND pin location.
Just to check I set the gyro servo out to 1520us/333Hz I will try the fix in the morring
sonnier00 is offline Find More Posts by sonnier00
Last edited by sonnier00; Sep 28, 2012 at 12:39 AM.
Reply With Quote